Product Remote Part No. Manual Part No. Revision Effective Date; Proflame GT: 910-592: 946-682: Proflame GTM: 910-592: 946-682: Proflame GTMF: 910-592: 946-682. I took a look at the owner's manual for the Atwood RV Carbon Monoxide and Propane Gas Detector # AT36681 and it does specify that if the Fault Mode will not clear then 'the detector is not functioning properly and must be replaced' as you can see by the accompanying cutout of the manual I added. I have added a link to a video review for you to check out as well. 1-16 of 113 results for 'atwood lp gas detector series 2001' RecPro RV LP Detector Atwood RV Propane Detector LP-DC Leak Detector Alarm White 4.6 out of 5 stars 80. Airport utility 5.6 for mac. 12VCD Marine Gas Detector (23) – #1300-7720 (Detector Only) Marine UL Listed with red function light. Remains ON and monitoring even when Gas Control Panel is OFF.
Description
Surface mount Flush mount
End False Alarms
Long Life
Intelligent Sensor
Minimal Power Draw
Easily Reset
DC or Rectified AC Super sonic 64 rom.
The Protechtor Series monitor features a microprocessor sensor combination that actually records & displays low level concentrations of gas, and indicates their presence before they become a threat as well as recording the low level presence over time. Low levels of carbon monoxide over time is almost as great a hazard as high levels. They also feature the highest level of discrimination against false alarms due to high humidity or other gases and vapors such as hair spray, ammonia or alcohol.
Protechtor Lp Gas Detector Manual
Should the alarm be triggered, only Atwood?s Protechtor series has the UL approved feature that allows the consumer to silence the unit. If the level of gas has not gone down after 4 minutes, the alarm sounds again. The alarm may be reset an unlimited number of times and each time is refreshed to allow full sensing capabilities in less than 5 minutes. Grundig serial number code calculator v1.00 download.
Protechtor Lp Gas Detector Series 2001 Manual For Sale
Minimal power consumption of only 120mA at 12 volts DC. These units will operate on a DC supply source providing versatile hook-up options. The detector will continue to operate down to 8 volts DC, when virtually all systems have shut down due to low power. Can be flush mounted or surface mounted.
